s500mc en 10149-2 automobile structure steel bridge steel plate

High-quality alloy steel is made of high-quality carbon structural steel by adding one or several alloying elements (the total mass fraction does not exceed 5%). The alloying elements contained are of different types and contents, and the corresponding pr

High-quality alloy steel is made of high-quality carbon structural steel by adding one or several alloying elements (the total mass fraction does not exceed 5%). The alloying elements contained are of different types and contents, and the corresponding properties are also different. High-quality alloy steel is mainly used to manufacture various parts that are larger in size, more complex in shape and difficult to meet performance requirements with high-quality carbon steel. Through proper heat treatment, S500MC EN 10149-2 automobile structure steel, high-quality alloy steel can obtain higher strength and toughness.

Erosion wear of wear-resistant steel plates is very common, because rain erosion is an inevitable natural damage. Since the problem cannot be solved from the source, we should take appropriate measures to reduce the damage to a lower level. To this end, we can properly refurbish the wear-resistant steel plate, s500mc en 10149-2 automobile structure steel. The method of electrothermal welding is adopted for the connecting parts of the wear-resistant steel plate, and the plate is well fixed, and the brittleness of the plate is reduced as much as possible. So that the plate can not be damaged when it is subjected to wind and rain.

Cold rolled s500mc en 10149-2 automobile structure steel steel sheet can be produced by two high mill, four high reversing mill, multi high reversing mill and tandem cold mill. Although there are still only two work rolls in four high and multi high rolling mills, each work roll is supported by one or more large diameter backup rolls, which can prevent deflection of work roll. As a result, wide and thinner s500mc en 10149-2 automobile structure steel steel plates can be produced. For example, 20 high mill can produce as thin as 0. 001 mm sheet, but the two high mill can only produce as thin as 0. 35mm sheet

After-sales service team is a key department to test the steel quality. Product quality is always the foundation of our survival and development. The company's full inspection from raw materials to finished products; and implements standardized, scientific, and strict internal quality control and management systems in accordance with the process flow during the production process; products can only leave the factory if qualified, and follow-up problem solving systems are implemented in after-sales services to guarantee the customers’ interest.