We are Ready For any places moving!

Hot rolled plate S700MC automotive steel sheet 50mm thick plate rate

Hot rolled plate S700MC automotive steel sheet 50mm thick plate rate

With the development of China's market economy, the company vigorously implements the strategy of industrialization, internationalization and diversification, promotes the group operation, intensive development and lean management, and through a rich

Hot rolled plate S700MC automotive steel sheet 50mm thick plate rate

With the development of China's market economy, the company vigorously implements the strategy of industrialization, internationalization and diversification, promotes the group operation, intensive development and lean management, and through a rich series of products and project portfolio as well as a complete operation network, Build the company into a modern enterprise with scientific development concept, continuous innovation vitality, excellent corporate culture, strong sense of social responsibility and international first-class competitiveness.

S700MC automotive steel sheet, 27SiMn material has high strength and wear resistance, high hardenability, medium plasticity during cold deformation, good machinability and fair weldability. It is mostly used after quenching and tempering, and can also be used in normalizing or hot rolling state. 27SiMn material chemical elements: C: 0.24-0.32, Si: 1.10-1.40, Mn: 1.10-1.40. 27SiMn material mechanical properties: tensile strength 980 MPa; yield strength: 835 MPa; elongation after fracture: 12%; impact energy: 39J. 27SiMn material can be used to make hot stamping parts with high toughness and high wear resistance, which do not need heat treatment or normalizing, such as tractor track pins.

The steel such as S700MC automotive steel sheet delivered in the hot-rolled state has a certain degree of corrosion resistance due to the high temperature, so it can be stored in the open air. However, this layer of oxide scale also makes the hot-rolled steel surface rough and the size fluctuates greatly. Therefore, the steel with smooth surface, accurate size and good mechanical properties is required to be produced by using hot-rolled semi-finished products or finished products as raw materials and then cold rolling.

The company supplies more than 2,000 tons of pressure vessel steel materials to the Nigerian customer for the construction of atmospheric pressure tower in the refinery. This batch of S700MC automotive steel sheet pressure vessel steel materials are tailored according to customer requirements, and the composition and process are newly designed. The performance of the pressure vessel steel materials meets the requirements of properties such as resistance to tempering embrittlement and hydrogen corrosion, and S700MC automotive steel sheet special properties such as good formability, weldability and adaptability to welding process.

The quality inspection department is responsible for the inspection management of raw materials and finished products, and the quality inspection and acceptance of products and raw materials. Strictly abide by the company's management system, conscientiously exercise the management power given by the company, and put an end to all ultra vires; be responsible for the inspection of all kinds of raw materials entering the company, and put forward quality problems and handling opinions.

On March 26, 2020, the Mexican Ministry of Economic Affairs issued an announcement in the official gazette that the fourth anti-dumping sunset review investigation was initiated on S700MC automotive steel sheet, hot rolled steel plates originating in Russia and Ukraine and boron-containing hot rolled steel plates originating in Russia. The TIGIE tax numbers of the steel products involved are 7208.10.99, 7208.26.01, 7208.27.01, 7208.38.01, 7208.39.01, 7225.30.04, 7225.30.05, 7225.40.03 and 7225.40.04.

Leave a message

Your email address will not be published. Required fields are marked *