1200 tons pickled steel sheet s420mc coil to Bangladesh in 2016

Hyundai Steel Co. has no plans to cut production further despite weak steel demand due to the coronavirus pandemic, the company's president said. Earlier this year, South Korea's second largest steelmaker reduced its pickled steel sheet s420mc a

Hyundai Steel Co. has no plans to cut production further despite weak steel demand due to the coronavirus pandemic, the company's president said. Earlier this year, South Korea's second largest steelmaker reduced its pickled steel sheet S420MC annual production of hot rolled coils from 1 million tons previously to 700 thousand tons per year for EAFs. A turnaround is expected after the third quarter of this year. In the three months to March 31, Hyundai Steel had a net loss of 88.6 billion won ( million), up from 94.4 trillion won in net profit in the same period last year.

In line with the service concept of "honesty first, customer first" and the service tenet of "all for customer satisfaction", the company adopts the acceptance and response mode of combining manual and automatic, and accepts the diversified service demands of customer business consultation, complaint declaration, business acceptance, etc. through telephone, fax, e-mail, visit, letter, etc.

In 2014, we offered 175 ton Cold rolled stainless steel plate to Thailand. The pickled steel sheet s420mc products are from TISCO. Here is the MTC that we offered to customer. We have our own quality team. Our quality team will inspect every order before shipment for customer. Normally, we will test the chemical composition, thickness, width, and length. Here are some pictures for last inspection.

The advantages of flame cutting are simple cutting and low cost. The disadvantage of flame cutting is that when cutting thin plates, cutting deformation problems are prone to occur, and the materials that can be cut have certain limitations. The advantage of CNC cutting is that it can cut pickled steel sheet s420mc and any complex parts with high cutting accuracy. The disadvantage of CNC cutting is that there are certain operational and technical requirements.

In the manufacturing process of boiler pressure components, raw materials must undergo complex processing deformation and welding, so the steel used to manufacture the boiler must also have good process performance. All materials pickled steel sheet s420mc used to manufacture pressure parts must conform to the relevant national standards for boiler steel. The defects such as delamination, non-metallic inclusion, porosity and looseness in the steel shall be as few as possible, and white spots and cracks are not allowed.

Strengthen system construction. The system itself has a certain binding force, which specifies the rights and obligations of employees. It is a passive management means for employees. Its purpose is to promote each employee to develop good professional habits, form good behavior norms, and promote the improvement of enterprise management level.